This model was inspired by a Naboo N-1 Starfighter plastic model picture that I found on the net, it looks very stylish so I think it will be good if I make this fighter into paper model.
Parts 1-3 :
- Bend part number 1 and glue the gap on the side
- Assembly blaster cannon housing (2&3) on part number 1 from the bottom.
Parts 1 and Ribs
- Glue front ribs (R1 - R5) to the bottom of part number 1
- Bend part number 1 and glue it to follow the ribs profile
Parts 1 and Ribs
- Glue front ribs (R1 - R5) to the bottom of part number 1
- Bend part number 1 and glue it to follow the ribs profile
Parts 1 & 2
- Attach part number 2 to part number 1 which already has ribs on it
- Bend part number 2 and follow the line profile of the ribs
Tail Parts
- Do same for tail parts just like front parts
Cockpit
- Assembly front parts and tail parts
- Glue the fuselage right on the end edge of front parts
- Attach the cokcpit glass (#15)
- Glue the astromech droid housing, and attach the droid on top of it
Engines :
- Assembly engine parts, 20-27. Left or right is the same.
- Attach the blaster cannon (#5) on its housing
- Assembly the engines and wings on its place just like the picture above
Display Stand
- Assembly Display stand (28 & 29)
