- Details
- Written by: Julius Perdana
- Category: Gundam
This release is the last part of a complete unicorn gundam without accessories. This Unicorn is not finish yet, there will be more parts for shield and its cannon. The Unicorn's appearance when the system 'NT-D' is active. In this way, the psyco frame structure built in mobile whole body reads the thoughts of the pilot (psycowaves), which directly influence the movements of the unit. In other words, the Mobile Suit can be controlled solely by thought. However, when compared to the human body, the stress of gravity of a Mobile Suit from 20 meters, more than ten times the size of the human body is shaking. Even with the aid of psycommu the mind of the driver can only support an operation period of no more than five minutes, after which it is believed that a limiter is activated, returning the unit to the way Unicorn. This system does not act according to the will of the pilot, but automatically, when certain conditions are met, supposedly when the unit detects an opponent Newtype.
- Details
- Written by: Julius Perdana
- Category: Gundam
Final part for unicorn gundam papercraft exclude accessories. The leg parts are poseable. The overall leg parts is shortened if compare to plastic model version and simplified at some details. The next release of gundam category would be its back booster. Happy building.
- Details
- Written by: Julius Perdana
- Category: Gundam
New parts for Unicorn Gundam. This parts are arms parts, consist of 4 letter pages. I use new type of joints for this unicorn fingers, flat joints. Instructions are for left hand only, the right one use the same numbers but the parts are mirrored. There will be 3 parts to go, legs, back booster - backpack, and accessories such as weapons and shield.
- Details
- Written by: Julius Perdana
- Category: Gundam
The waist part for unicorn gundam destroy mode papermodel. I had to re-design some parts a few times before came up with this release, to make it easier to build and come with fewer parts. Shoulder joint design work pretty good just like the way I have expected, in this release I design new joint, trying to apply two ball joints for the hips. I hope this design will works too and minimize additional joints for leg movements. Next primarly release will be optimus prime arm parts.
- Details
- Written by: Julius Perdana
- Category: Gundam
Two pages of pattern for this unicorn gundam's shoulder. My plan was to release complete arm parts, but it would take too long. This is my first paper model with articulated joints, I hope it will work. And the important thing is I want to maintain my mood by not take too long to designing a single subject. I also still take sometime on modeling OP arms. Unicorn shoulder is supposed to release after my work in progress OH-58D Kiowa Warrior, but I switched to gundam in the middle of detailing its 3d model.