- Details
- Written by: Julius Perdana
- Category: Gundam
New parts for Unicorn Gundam. This parts are arms parts, consist of 4 letter pages. I use new type of joints for this unicorn fingers, flat joints. Instructions are for left hand only, the right one use the same numbers but the parts are mirrored. There will be 3 parts to go, legs, back booster - backpack, and accessories such as weapons and shield.
- Details
- Written by: Julius Perdana
- Category: Gundam
The waist part for unicorn gundam destroy mode papermodel. I had to re-design some parts a few times before came up with this release, to make it easier to build and come with fewer parts. Shoulder joint design work pretty good just like the way I have expected, in this release I design new joint, trying to apply two ball joints for the hips. I hope this design will works too and minimize additional joints for leg movements. Next primarly release will be optimus prime arm parts.
- Details
- Written by: Julius Perdana
- Category: Gundam
Two pages of pattern for this unicorn gundam's shoulder. My plan was to release complete arm parts, but it would take too long. This is my first paper model with articulated joints, I hope it will work. And the important thing is I want to maintain my mood by not take too long to designing a single subject. I also still take sometime on modeling OP arms. Unicorn shoulder is supposed to release after my work in progress OH-58D Kiowa Warrior, but I switched to gundam in the middle of detailing its 3d model.
- Details
- Written by: Julius Perdana
- Category: Gundam
Continuing Unicorn Gundam head on previous post, here is the second part, which is its torso. I plan to make this gundam paper model poseable. This release was nearly postpone because of my computer processor fan stuck and jammed causing proscessor to stop working because of over heating, So I hwent out at night looking for fan parts. Luckily there is a small computer repair not far from my house that I never take a look seriously until that time. The computer guy took about 2 hours repairing my computer.
- Details
- Written by: Julius Perdana
- Category: Gundam
This is my first gundam paper model. I plan to release part by part, this is the first head part. The RX-0 Unicorn Gundam was first seen by Anaheim Electronics student Banagher Links while it was on a test run. The Unicorn flew by the colony at an extremely fast rate, but Banagher was able to make it out as a mobile suit. The Unicorn Gundam is piloted by a Vist Foundation Pilot, Gael and the head of the House of Vist. Cardeas Vist put a lot of stress on the pilot when they entered a debris field during a test excercise near the Colony Industrial 7. When the test ended Gael notified Cardeas that some people might have seen the MS, but Cardeas said that the people would probably think it was a shooting star.