You are here:: Instructions RC Projects Douglas DC-3 Part 5 RC Plane

Douglas DC-3 Part 5 RC Plane

E-mail Print

This is the final episode of Douglas DC-3 or C-47 RC plane build. It's primary using 3mm and 5mm depron or polyfoam or XPS foam. This last video is covering about making the wing, wing fairing, install landing lights, and other accessories like detail of the engine cowl and battery hatch door. The CG of this model is 12 cm from the leading edge, by using 2X 3S Lipo battery it will ballanced perfectly. You can have 8 minutes of flight time using 2 lipo batteries. This plane is a good flyer, short take off, scale speed, and easy to control using combination of aileron and rudder. The landing is also smooth and slow, no flap needed. Unfortunately the retract landing gear was the only downside, one of the servo is failed.

Specs :

1. Wingspan 2200mm / 87 inches

2. Flying weight : 2550 gram / 89.9 oz

3. Wing loading : 46.2 gram/ 15.1 oz/sq.ft

4. Wing cube loading : 6.2

5. Wing Area : 55.21 dm2 / 856 sq.in

6. CG :12 cm from LE

Electronics

- 2X Turnigy/DYS 2830 1000kv brushless motor

- 2X ESC 40A

- 2X Battery Lipo 3S 2200mah - Li-ion 3S 3300 mah

- 4 plastic gear 9 gram servos

- 5 metal gear 9 gram servos

- 2X Propeller : 9x6x3

Materials :

1. 5mm Depron/ Polyfoam/ XPS foam

2. 3mm Plywood

3. 0.3mm + 0.5mm Mica Plastic

4. hot glue + CA glue + UHU glue

5. laminating film

6. packing tape

Open the PDF file with Adobe Acrobat Reader (recommended software)

PDF security password : none

{ads2}

Douglas DC-3 Part 5 Plans A4

Douglas DC-3 Part 5 Plans A0

https://youtu.be/KOep8jkr8Hg

Search