This model was inspired by a Naboo N-1 Starfighter plastic model picture that I found on the net, it looks very stylish so I think it will be good if I make this fighter into paper model.
{ads3}
Parts 1-3 :
- Bend part number 1 and glue the gap on the side
- Assembly blaster cannon housing (2&3) on part number 1 from the bottom.
Parts 1 and Ribs
- Glue front ribs (R1 - R5) to the bottom of part number 1
- Bend part number 1 and glue it to follow the ribs profile
Parts 1 and Ribs
- Glue front ribs (R1 - R5) to the bottom of part number 1
- Bend part number 1 and glue it to follow the ribs profile
Parts 1 & 2
- Attach part number 2 to part number 1 which already has ribs on it
- Bend part number 2 and follow the line profile of the ribs
Tail Parts
- Do same for tail parts just like front parts
Cockpit
- Assembly front parts and tail parts
- Glue the fuselage right on the end edge of front parts
- Attach the cokcpit glass (#15)
- Glue the astromech droid housing, and attach the droid on top of it
Engines :
- Assembly engine parts, 20-27. Left or right is the same.
- Attach the blaster cannon (#5) on its housing
- Assembly the engines and wings on its place just like the picture above
Display Stand
- Assembly Display stand (28 & 29)
You must agree on Document License agreement page first, choose agree on the radio button then you will proceed
Download
Open the PDF file with Adobe Acrobat (recommended software)
PDF security password : paper-replika.com
{ads2}
Naboo N-1 Starfighter paper model template
< Prev | Next > |
---|