Paper Replika

 
 
You are here:: Instructions RC Projects
 
 

RC Projects

ATR-72 600 RC Plane Part 1

E-mail Print

ATR-72 is twin turboprop engine made by France and Italy aircraft manufacture. Its main purpose is to be a commuter plane. In this episode I want to share with you on how to build nose section, landing gear and middle fuselage. It will be continued to other parts, maybe in 2-3 parts again. The wingspan in 1800 mm and for other specs you can look down on description below. The main material is  5-6 mm depron.

 

Read more

Mini RC Boat for Kids

E-mail Print

For this project we'll leave the air for a while and hit the water. I made a mini RC boat with waste foam material, which is small styrofoam meal box waste. You can also buy the foam box very cheap or by using 2mm depron foam or XPS foam. I also wanted to experiment for using only servo for the electronics. Inside servo there are few part that are mini ESC and off course mini brushed motor. I use all that parts for thrusting a mini boat. I also experimenting with differential thrust setup and more common setup with single prop and a rudder. Actually the result is better to use common setup with single prop and a rudder, because differential thrust tend to brings more problems, like steering difficulty, broke shaft and drained to many battery ampere. You can choose which setup to suit you best or even improving it.

 

Read more

Piper Cherokee RC Plane

E-mail Print

Piper Cherokee is a private and trainer plane. Made by Piper Aircraft. first flight in 1960. It still in production until now with variants Arrow, Archer and Warrior. This plane is very stable and easy for handling. I made an RC plane of it in semi scale model. I made its wing longer than the real one. The front wheel it's not steerable but don't worry you can still steer it on the ground with rudder.

 

Read more

Page 3 of 6