Paper Replika

 
 
You are here:: Home
 
 

Aircraft

Cessna 172 Skyhawk Floatplane Papercraft

E-mail Print

I don't remember exactly the last time I design an aircraft beside the airliner series. Aircraft has been my passion for so long, and because that passion I was introduced to papermodel as a hobby until now. I love this cessna 172 Skyhawk a lot. This model is quite small, only 23 cm wingspan, with 1:48 scale it is perfect for your desk decoration, and it only needs 2 sheets of paper, recomended to use 160 gsm BC or 120 gsm inkjet paper. I also make a change on the entire web regarding this aircraft, I notice there are enough aircraft models to have their own category instead be inside transportation category. Cessna 172 Skyhawk is a single engine with 4 seat, with its wing on top the fuselage (high wing). Cessna 172 is the most widely use plane ever built, compared to other aircraft. And the most successful light aircraft ever produced from 1956 to date. In 2008 at least 43,000 cessna 172 had been rolled out from the production hangar.

Read more

Piaggio P180 M Avanti Papermodel

E-mail Print

Sounds like a scooter manufacturer, but it is an high tech aircraft from Piaggio Aero. This is a scale model 1:72 of P180 M which is a military version of Piaggio P180 Avanti civilian executive transport. P180 M primarly use by Aeronautica Militare (Italian Air Force), they equipped with military standard such as FLIR, SAR radar dan surveillance systems. This release use inner glue tabs and formers.

Read more

X-51A Waverider Papermodel

E-mail Print

The Boeing X-51A Waverider is an experimental aircraft cooperative effort of the United States Air Force, DARPA, NASA, Boeing and Pratt & Whitney Rocketdyne. It is a scramjet aircraft that capable of traveling in Mach 6 or around 6,400 km/h in its last successfully first free flight on 26 May 2010. The program is managed by the Propulsion Directorate within the United States Air Force Research Laboratory (AFRL). The X-51A had its first captive flight attached to a B-52 in December 2009.

Read more

F-15i Ra'am - IDF Eagle

E-mail Print

F-15i Ra'am - IDF EagleMy first jet fighter that I design with a computer. It was a commercial model, released in 2008. F-15I is a dual-role long range fighter for attack and interception. The plane - the best of its type in the Middle Eastern arena - entered service in January of 1998, and is the IAF's lead plane. The Ra'am is a special version of the F-15E Strike Eagle that was designed specifically for Israel by McDonnell Douglas (now Boeing). Its tremendous payload capacity, combined with its advanced systems, enable it to carry out depth attacks with a large weapons load, at long ranges, at low altitude, in all hours of the day and night and in any weather conditions.

Read more

MQ-9 Reaper 1/32

E-mail Print

The latest United States Air Force Strike Unmanned Aerial Vehicle (UAV). It is a development and derivative of its brother MQ-1 Predator A. Bigger, faster and even deadlier hunter killer UAV, designed for long flight and high altitude surveillance. USAF has 28 Reapers which 10.5 USD million each unit cost. This paper model is a request from a friend at papermodelers.com forum. I use 1/32 scale, with formers and inner glue flaps or glue tabs, make this model suited for advanced builder.

MQ-9 Reaper 1/32

Read more

Page 5 of 8