Paper Replika

You are here:: Home

Zobel Light Reconnaissance Vehicle Paper Model

E-mail Print
Article Index
Zobel Light Reconnaissance Vehicle Paper Model
Page 2
All Pages

I have been preparing for this model since long, but only in the form of 3d models. Because of the limitations and the lack of reference blueprint images then makes this model less accurate. I only use a few photos to make this model. Based on the vehicle length obtained from the specification data, I made this model in 1 / 35 scale. The Zobel is produced by German military vehicle manufacturer GST (Gesellschaft fur Systemtechnik mbH) for light reconnaissance vehicles. Four-wheel suspension can be raised so that the vehicle body can be lifted upward to drive in off road terrain. The Zobel has not been actively used, it is still a prototype. File opening password :

You can use black marker pen to color white surfaces on each sides of every parts, color those white surfaces before you glue each parts. I think the use of black marker is a must, unless you already happy with white stripes all over your model.


File opening password :


The Zobel has 4 × 4 drive with steering on all four wheels. The vehicle is fully amphibious being propelled in the water by two propellers mounted at the front of the hull, one on either side. These propellers swivel to steer the vehicle when afloat. If required, the rear observer could also drive the vehicle for a short period. Standard equipment includes a complete range of communications equipment, an NBC system, a front-mounted winch for self-recovery operations and a central tyre pressure regulation system which allows the driver to adjust the tyre pressure when the vehicle is moving.

You must agree on Document License agreement page first, choose agree on the radio button then you will proceed

Open the PDF file with Adobe Acrobat (recommended software)

PDF security password :

Zobel Light Reconnaissance Vehicle Paper Model templates

Zobel Light Reconnaissance Vehicle Paper Model
More articles :

» Unicorn Gundam Papercraft - Hyper Bazooka

This is the last part of complete Unicorn Gundam paper model by Paper Replika. It supposed to be...

» Built Dragunov Sniper Rifle Photos

This nicely done dragunov papercraft is build by Josh Hughes (Sidewinder81777). I found these...

» British Aircraft Corporation TSR-2 paper model

Recent work from Rizky Ferriansyah (paperhobby), this time he made a 1 / 72 scale model  of a...

» XM1203 NLOS - Cannon

New model from Rizky Ferriansyah ( The XM1203 Non-Line-of-Sight Cannon ...

» Panzer VIII Maus Tank 1:35

Another German tank papermodel from paperhobby. Rizky made it in 1:35 scale. After completion of...

» Photos of Built M8 Avenger and other models

New photos have been added to Paper Replika Gallery. They are Mass Effect M8 Avenger assault rifle...

» Unicorn Gundam Papercraft (Leg)

Final part for unicorn gundam papercraft exclude accessories. The leg parts are poseable. The...

» Merkava Mark II Main Battle Tank

Merkava / Merkabah / Chariot Mark II was first introduced into general service in April 1983 and...

» Unicorn Gundam Papercraft - Beam Magnum

Second wave of unicorn gundam paper model parts design marathon. This part is a Beam Magnum. Just...

» Built Photos of Scout Trooper 1/12

As usual Taufik always been a super fast builder. This morning he tagged me "again" on his facebook...