Paper Replika

 
 
You are here:: All Paper Model
 
 

Instructions

Windsock for RC Flying Field

E-mail Print

This project is very simple, how to make wind direction windsock using simple and cheap material, which is plastic bags. Windsock is very useful for an RC flying field, it shows the RC pilots which way to take off and landing. Beside useful as a wind direction tool it also decorate your RC field to looks like a real aircraft runway strip, which a windsock always visible. How to make process and calibration is covered in this video.

Read more

Cessna 172 RC Plane

E-mail Print

You can build yourself Cessna 172 model plane by following build tutorial on this video. The tutorial is pretty straight forward with easy to understand steps. Start from foam sheet into flying the plane itself with brushless motor electric power and control by radio. Painting process is also covered in this video. This model plane use color from the real plane, it's belong to an Indonesian famous pilot Youtuber Captain Vincent Raditya. This plane is pretty stable and easy handling, but not recommended for beginners who never flown an RC model plane before. The scale looks of this plane is very interesting to see when flying in the air. Take off and Landing are also scale like.

 

Read more

ATR-72 600 RC Plane Part 4 Complete

E-mail Print

Before maiden flight, we need to finish the aircraft with few steps, like making a battery hatch door, maintenance hatch door, marking the CG position, attaching control horns and pushrods. Maiden flight was scheduled on last Saturday but failed because one of the ESC is different and causing different speed from each motor. It finally flew well on Monday and Tuesday after both ESC were replaced.

 

Read more

ATR-72 600 RC Plane Part 3

E-mail Print

In this last part of building ATR-72 600, I'm going to share with you how to make wing and motor mounting, also aileron and flaps. In this ATR we're going to make flap hinge from 3mm plywood. This plane use twin turnigy 1400kv motor with 7x4 3 blade prop. The livery of this plane is Citilink

Read more

How to Make ATR-72 600 RC Plane Part 2

E-mail Print

This is part 2 for building ATR-72 600 RC plane. In this episode I will cover about building the tail section, stabilizer and wing mounting. By looking at this second video, I hope I can finish it in part 3 and maiden flight in part 4, which also including all previous parts combined together in just single tutorial. The main things I share on this episode is how to bend and roll depron foam and how to glue and assembly the parts.

 

Read more

Page 1 of 115

  • «
  •  Start 
  •  Prev 
  •  1 
  •  2 
  •  3 
  •  4 
  •  5 
  •  6 
  •  7 
  •  8 
  •  9 
  •  10 
  •  Next 
  •  End 
  • »