Paper Replika

 
 
You are here:: Home
 
 

Bango 1 RC plane for Beginners

E-mail Print
Article Index
Bango 1 RC plane for Beginners
Page 2
Page 3
All Pages

I have many request for releasing a simple RC plane plans for beginners, so I decided to designed one. This plane is designed specifically for beginners that still learn how to fly an RC plane and to familirized the orientation. Beginner tends to broke front propeller so I put the prop on the back. Beginners tend to have slow reflex after taking off so I made the wing with big amount of dihedral angle, about 8 degree. So the plane will autolevel by itself. Taking off is also pretty easy just push the throttle it will take off by itself without touching elevator or rudder sticks. It also easy to build only uses 2 servos (3 channels) and very robust construction if it built right. It crashed on maiden but it can stand the test and survived.

 

 

Specs
- Wingspan : 114 cm / 45 inches
- Fuselage length : 98 cm / 38.6 inches
- Flying weight :  812 gram / 28.6 oz
- Wing Loading :   33.1 gram/dm2 / 10.8 oz/sq.ft
- Wing Area : 24.5 dm2 / 380 sq.in
- Wing cube loading : 6.7

Recommended Electronics :

- Any configuration with 28, 22. motor
- 9 inch prop maximum without LG, with LG 8 inch and 7 inch for rough terrain (CW/CCW)
- battery : 3s/4s 1500 - 4500 mah
- 2x servo 9 gram
- ESC 30-40A
- Any TX/RX as long it's hobby grade

Electronic for testing :

- motor Turnigy DST 1200kv
- ESC 50A
- prop CW 7x3.5x3
- Battery Lipo 3S 2200mah & Li-ion 3S 3000mah (LG HG2)
- 2 x 9 gram plastic servo
- TX/RX Turnigy 9X + FRsky DJT

Materials :
- 6 mm Depron (no paper skin)
- 3 mm plywood
- 7 x hot glue sticks
- White packing tape
- Bicycle wheel spoke wire / piano wire (2.5 mm)
- Nylon thread
- CA glue
- 3x 40 cm (1.5 mm) pushrod 
- velcro

BUILD INSTRUCTIONS :

 

BUILD INSTRUCTIONS  to be continued to the NEXT page

Open the PDF file with Adobe Acrobat Reader (recommended software)
PDF security password : none



Download Bango 1 RC plane for beginners plans